Jwin JX-CD483D MP3 Player User Manual


 
Portable MP3 CD Radio Cassette Recorder V10M10_IM_EN_11132007
www.jWIN.com
7
GETTING STARTED
Location of Controls
1. CD DOOR 17. CASSETTE PLAY BUTTON
2. BASS BOOST BUTTON 18. CASSETTE RECORD BUTTON
3 VOLUME KNOB 19. LCD DISPLAY
4. FOLDER+ BUTTON 20. FM STEREO LED INDICATOR
5. FOLDER- BUTTON 21. SPEAKER LEFT
6. SKIP/SEARCH+ BUTTON 22. SPEAKER RIGHT
7. SKIP/SEARCH -BUTTON 23. CASSETTE DOOR
8. 10+ BUTTON 24. BATTERY COMPARTMENT
9. STOP BUTTON 25. FM ANTENNA
10. PLAY/PAUSE BUTTON 26. BAND SWITCH
11. MODE BUTTON 27. AUX IN JACK
12. PROGRAM BUTTON 28. HEADPHONE JACK
13. CASSETTE PAUSE BUTTON 29. FUNCTION SWITCH
14 CASSETTE STOP BUTTON 30. AC SOCK
15. CASSETTE F.FWD BUTTON 31. AC 110/ 220V SWITCH
16. CASSETTE REWIND BUTTON
AC Operation
Before operating the JX-CD483D, make sure that the voltage on the unit corresponds to the
voltage of your local area. Unravel the AC Line Cord; insert one end into an AC socket on the
unit and the other end into a standard AC outlet.
1. In case of malfunction due to electrostatic discharge (ESD), reset the unit by
reconnecting the AC cord again to resume to normal operation.
2. When not in use, unplug the AC power cord from the AC power socket.
3. You may adjust the voltage of the unit using the AC 110/ 220V switch located at “31”
on Location of controls of the unit.
Battery Operation
Disconnect the AC Cord. Open the BATTERY COMPARTMENT and insert 2/UM-“C” size x 8
batteries (not included) making sure that the battery polarity (+/-) is observed.
Remove the batteries if the unit will not be used for a long period of time.
Antenna
For best FM reception, fully extend the FM ANTENNA. For AM reception, the unit has a built-in
antenna, turn the whole unit for best reception.
Bass Boost
To increase bass at all volume levels, push the BASS BOOST BUTTON to ON position to
boost the low frequency tone for an emphasized bass sound. To release the super bass, simply
push the button again.
Auxiliary (AUX) Mode
1. Slide the FUNCTION SWITCH to the AUX position.
2. Connect the earphone socket from the Auxiliary unit (e.g. MP3 player or MD player)
into AUX-IN jack on the rear of this product via an Audio Line Cord (3.5mm plug on
both ends; not supplied).
3. Play the Auxiliary unit. Music from the Auxiliary unit can be listened through the
speaker of this product.