Filter
Top Products
3
XL-MC222BK
?????
Installing batteries in the remote
control
1. There is a cover for the
battery compartment on
the back of the remote
control. Press the cover
down and slide it downward
to remove it.
2. Set the two accessory
batteries (1.5V, R6P, AA) in
the compartment with their
polarities in proper positions.
3. Place the cover over the
compartment, press it
down, and slide it upward
so that it firmly covers the
compartment.
CAUTION
• Install the batteries with their polarities correctly set.
• Remove the batteries if the remote control is not
going to be used for an extended period of time.
• Do not expose the remote control to heat, flame, or
direct sunlight.
Replacing the batteries
The service life of batteries normally lasts for about one year though
it is dependent on the use of the remote control (it is shortened in
low temperatures, too). Replace the batteries any time if the
controllable range is reduced (max. range: 7 meters or 23 feet and
30 degrees away from the component).
CAUTION
• Be sure to replace them with the correct batteries (1.5V,
R6P, AA).
• Do not use new and old batteries in combination.
3. Connect the accessory AC power cord into the socket in the
back of this unit. Then insert the cord plugs into an AC outlet.
(Do not connect the power cord to a switched AC outlet of a
component if the CompuLink system is used.)
AC POWER CORD
Wall outlet
AC power cord
XL-MC222/E B 97.7.15, 5:54 PM3