Filter
Top Products
11
XL-MC222BK
?????
The CompuLink system, which is a JVC-developed remote control
system, links JVC audio components to establish systematized
operation control of the linked components.
NOTE: There are three versions of the CompuLink system:
CompuLink-1, -2, and -3. Although they are basically
compatible, some functions may not be available with
the older versions (refer to the instructions manual of
the component for the information).
The CompuLink-3 Remote Control System provides the following
functions:
Automatic power on/off
Turning a linked component on or off will automatically turn the
amplifier/receiver on or off.
Selecting a source on the amplifier/receiver will turn on the relevant
component.
CAUTION
• Be sure to use the accessory CompuLink cable for the
connection.
• The operation may be disrupted if the power supply to a
component is interrupted, in which case turn off all linked
components and turn them on again.
Automatic source selection
Selecting a source on the connected amplifier/receiver will
automatically turn on the relevant component and start its operation.
Starting a linked component will automatically select the relevant
source on the amplifier/receiver.
Synchronized recording
This function is effective when a JVC cassette deck is linked in the
CompuLink system, allowing simple, synchronized recording.
NOTE: Refer to the instruction manual of your cassette deck
for the detail of the synchronized recording.
Some functions are disabled in order to prevent the
recording trouble during the synchronized recording.
Playing the program repeatedly
To repeat playback according to the program, press the REPEAT
button, and select and show “REPEAT” on the display. Then start
playing, which will be repeated until stopped.
This function can be used in the basic PROGRAM mode as well as
when the RANDOM function is effective.
Press the REPEAT button twice to cancel the function, clearing the
indication from the display during stop.
Playing a program step
repeatedly
To repeatedly play a specific program step, select the step using
or buttons during playback, press the REPEAT button
twice and show “REPEAT 1” on the display. The selected step is
played back repeatedly.
This function can be used in the basic PROGRAM mode as well as
when the RANDOM function is effective.
Press the REPEAT button once to cancel the function, clearing the
indication from the display.
COMPULINK-3
REMOTE CONTROL
SYSTEM
XL-MC222/E B 97.7.15, 5:59 PM11