Filter
Top Products
4
Preparing remote control
When you use the remote control for the first time, pull out
the insulation sheet.
To replace the battery in the remote control
Caution
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• Store the battery in a place where children cannot reach.
If a child accidentally swallows the battery, consult a
doctor immediately.
• To prevent the battery from overheating, cracking, or
starting a fire:
– Do not recharge, short, disassemble or heat the
battery or dispose of it in a fire.
– Do not leave the battery with other metallic materials.
– Wrap the battery with tape and insulate when
throwing away or saving it.
– Do not poke the battery with tweezers or similar tools.
• Dispose of battery in the proper manner, according to
federal, state, and local regulations.
• The battery (battery pack or battery installed) shall not
be exposed to excessive heat source such as sunshine,
fire or the like.
Preparing FM antenna
Extend the FM antenna so that you can obtain the best
reception.
• Make sure the antenna conductor does not touch any
other terminals, connecting cords or the power cord.
Also, keep the antenna away from metallic parts of
the System, connecting cords, and the AC power cord.
Otherwise, it could cause poor reception.
Connecting power cord
Be sure to connect the power cord to wall outlet after all
other connections have been made.
Set the clock before using this System (see page 6).
Getting started
To wall outlet
FM antenna
English
EN_NX-PB10[J].indb 4EN_NX-PB10[J].indb 4 10.12.8 11:08:51 AM10.12.8 11:08:51 AM