Jensen SMPV-4GBEB MP3 Player User Manual


 
4
POWER SOURCE & RECHARGING
This unit operates on a built-in Li –polymer battery and must be
charged prior to use.
Please charge the unit for at least 8 hours before first use.
1. Connect the PC USB port and the unit’s USB port with the
provided USB cable.
2. An animating battery icon will appear as
shown in the diagram on the right during
charging. Once full charged, the battery
will stop running. The average recharging
time is approximately 3 hours for normal
use.
3. To stop the charging process, disconnect the USB cable.
Notes
Your computer must be turned on while connected to your
player for charging.
Do not overcharge the player after the initial charge.
Overcharging could shorten the battery’s life and charging
capacity.
The built-in Li-polymer battery will normally offer about 300 or
more charge/discharge cycles.
The Li-polymer battery will discharge slowly on its own even
when the unit is not in use, so if the unit is not used for an
extended period of time it will be necessary to recharge the unit
at least once every 6 months to maintain normal performance.
CAUTION
1. Danger of explosion if battery is incorrectly replaced.
Replacement should be by a qualified technician and only with
the same or equivalent type battery.
2. Do not disassemble, crush, short-circuit or incinerate your
battery as it may cause fire, injury, burns, explosion or other
hazards.