Filter
Top Products
5
INSTALLATION
This unit can be operated either using 4 x “AAA” batteries (not included) or with a
USB power adaptor with a rating of DC 5V, 1000mA via the mini USB connector
on the back of the unit.
USE THE BATTERY POWER
1.) Open the cover of the Battery Compartment located at the bottom of the unit.
2.) Install 4 X DC1.5V 'AAA' (UM-4) batteries (not included) into the battery
compartment by following the polarity markings shown inside. Alkaline batteries
are recommended for longer playing time.
IMPORTANT: Be sure that the batteries are installed correctly. Wrong polarity
may damage the unit and void the warranty.
For best performance and longer operating time, we recommend
the use of good quality alkaline batteries.
3.) Replace the cover on the battery compartment.
4.) After prolonged use, the battery voltage may discharge to such a low level that
it cannot work properly. In that case, you need to replace them all at once with
fresh good quality batteries. Remove all exhausted batteries and follow above
procedures to replace new batteries.
Battery Note and Care
Danger of explosion if the battery is replaced incorrectly. Replace only with
the same type battery.
Only use a good quality known brand battery to ensure the longest life and
best performance.
If the unit is not used for an extended period of time, remove the battery. An
old or leaking battery can cause damage to the remote and may void the
warranty.
Do not dispose of batteries in fire. Batteries may leak or explode.
Do not try to recharge batteries that are not intended to be recharged; they
can overheat, rupture and leak (Follow battery manufacturer’s directions).
Only an adult should replace the battery.
BOTTOM
AAA battery compartment