Filter
Top Products
Caution While Driving
Use of headphones while operating an automobile or moving vehicle is not recommended and
is unlawful in some states and areas. Be careful and attentive on the road. Stop operation of
the unit if you find it disruptive or distracting while driving.
Important Battery Information
•
When storing the unit, be sure to remove the battery because it may leak and damage the
unit.
•
Battery may leak electrolyte if inserted incorrectly, if disposed of in fire, or if an attempt is
made to charge a battery not intended to be recharged.
•
Discard leaky battery immediately. Leaking battery may cause skin burns or other
personal injury.
•
Do not charge batteries which are not intended to be recharged.
•
Dispose of batteries, according to federal, state and local regulations.
Headphone Safety
Have a Blast- Just Not in Your Eardrums. Make sure you turn down the volume on
the unit before you put on headphones. Increase the volume to the desired level only
after headphones are in place.
•
Do not play your headphone at a high volume. Hearing experts warn against extended high
volume play.
•
If you experience a ringing in your ears, reduce volume or discontinue use.
•
You should use extreme caution or temporarily discontinue use in potentially hazardous
situations. Even if your headphone is an open-air type designed to let you hear outside
sounds, don’t turn up the volume so high that you are unable to hear what is around you.
Insert battery into the player
1. To insert battery, open the battery door on back of unit.
2. Insert a “AAA” battery with polarities corresponding to the indications (+,-) on the
compartment.
3. Close the door to the battery compartment.
Note: Refer to the power level indicator on display for battery level.
Replace with new battery when the indicator is empty.
Using Headphone
Insert phone plug into the phones jack ( ) on the player for listening.
Connecting the Player to your Computer
Insert the small end of the provided USB cable into the socket on the unit tightly, then insert the
large end to the socket of the computer.
Shielded cables must be used with this unit to ensure compliance with the Class B FCC
Iimits.