Filter
Top Products
10
After all the programmed tracks have been played, the player stops but the programmed tracks
remain in the memory.
Press the PROGRAM Button followed by the PLAY/PAUSE Button to begin programmed
playback again.
7. To cancel programmed play, in Stop mode press the STOP
■
Button once or open the CD DOOR.
8. To turn the CD player off, set the FUNCTION selector to STANDBY/AUX position. The LCD
backlight will go off.
LISTENING TO YOUR iPod/iPhone
1. Gently push the iPod/iPhone compartment door to open it. The door will automatically open.
2. Place your iPod/iPhone into the docking port by placing the connector on the bottom of the
iPod/iPhone onto the connector in the docking bay. When the system is powered by AC,
iPod/iPhone battery charging will start automatically even if the Dock is in standby mode.
Note:
(1).
Please be careful when seating the iPod/iPhone into the docking to avoid damaging the
30-pin connector on the iPod/iPhone or in the Docking System. Dock your iPod/iPhone
carefully into the 30-pin connector and then close the door.
(2). The iPod/iPhone will only be charged when the System is powered by AC.
3. Close the iPod/iPhone compartment door, set the FUNCTION selector to the iPod/iPhone position,
the LCD backlight will light and display the message “iP”.
4. Press the PLAY/PAUSE
button to start play back.
5. Select the previous or next music tracks by pressing the B-SKIP
or F-SKIP Buttons
repeatedly, and press the PLAY/PAUSE
Button to play or pause.
Note: The System’s LCD will not show any music information (e.g. song name) for your
iPod/iPhone. Please view the music information through your iPod/iPhone display.
6. Adjust the sound level using the VOLUME control.
Note:
The volume level cannot be adjusted using the volume control on your iPod after docking.
7. To remove the iPod/iPhone from the unit, press and hold the PLAY/PAUSE
Button on the
System for a few seconds to switch off the device, open the iPod/iPhone compartment door and
then gently remove it from the dock connector.
8. To turn the iPod/iPhone mode off, set the FUNCTION selector to STANDBY/AUX position. The
LCD backlight will go off.
iPod/iPhone playback control:
Press the iPod/iPhone PLAY/PAUSE
button to pause or resume the iPod/iPhone
playback;
Press the SKIP
or buttons to skip to the next or previous song;
Press and hold the SKIP
or buttons for fast-forwarding or fast-rewinding during
playback.
From the remote, press the MENU button, ENTER button and / buttons on the remote