8
Note: The iPod will only charge when the JiSS-100 is using an AC power source.
5. Adjust the sound level by pressing the VOLUME / Buttons on the JiSS-100.
Note : The volume level cannot be adjusted using the volume control on your iPod after being
docked.
6. Press the or Buttons to skip to the previous or next song.
7. Press and hold the or Buttons to fast-backward or fast-forward during playback.
8. Repeatedly press the EQ Button on JiSS-100 to choose the desired equalizer effect.
Note : Set the EQ of your iPod to OFF so it doesn’t interfere with the EQ on this unit.
9. To remove the iPod from JiSS-100, press and hold the Button for few seconds to switch off
the iPod and then gently remove it from the docking connector.
10. To turn JiSS-100 off, press the
Power Button again.
USING HEADPHONES (NOT INCLUDED)
Inserting the plug of your headphones (not included) into the Headphone jack will enable you to listen in
private. When using headphones, the speakers will be disconnected automatically.
Note: READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES
1. Avoid extended play at very high volume as it may impair your hearing.
2. If you experience ringing in your ears, reduce the volume or shut off your unit.
3. Keep the volume at a reasonable level even if your headset is an open-air type designed to allow
you to hear outside sounds. Please note that excessively high volume may still block outside
sounds.
CARE AND MAINTENANCE
1. Avoid operating your unit under direct sunlight or in hot, humid or dusty places.
2. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent
lamps or motors.
3. Unplug the unit from the electrical power outlet immediately in case of malfunction.
Cleaning the Unit
To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning.
The finish on the unit may be cleaned with a dust cloth and cared for as other furniture. Use
caution when cleaning and wiping the plastic parts.
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or polish sprays
on the cabinet.
If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft cloth
slightly dampened with a mild soap and water solution. Never use abrasive cloths or polishes as
these will damage the finish of your unit.
CAUTION: Never allow any water or other liquids to get inside the unit while cleaning.