Filter
Top Products
11
Note:
i. The relevant Alarm Indicator will blink when the alarm time is reached.
ii. If you have chosen the “Wake to RADIO” alarm mode, make sure that you have
tuned to a station and adjusted the volume to a comfortable level.
iii.
After waking to beeping, iPod/iPhone or Radio alarm, the volume level of
the iPod or radio cannot be adjusted.
TURNING THE ALARM ON/OFF
With the JiMS-70i in STANDBY mode, briefly press the VOLUME + / ALARM 1 or
VOLUME - / ALARM 2 buttons once to activate or deactivate the alarm. The
Alarm 1 or Alarm 2 Alarm Indicator will appear or disappear on the display.
SNOOZE FUNCTION
When the alarm sound is on, press the SNOOZE/SLEEP/DIMMER button once. The alarm
sound will stop and resume after 9 minutes.
SLEEP TIMER
The sleep timer allows you to turn the unit off after a designated time is reached.
You can use the SLEEP Timer to fall asleep to Radio or iPod/iPhone for 90, 80, 70,
60, 50, 40, 30, 20 or 10 minutes intervals.
1.) Turn the unit on and either dock your iPod/iPhone or tune to the desired radio
station and set the volume to a comfortable level.
2.) Press the SLEEP button. The display will show 90 minutes of playing time and
then return to the current time mode in 10 seconds.
The JiMS-70i will automatically turn off after 90 minutes has elapsed.
3). Press the
SLEEP
button repeatedly to select a sleep time. Each time the Sleep
button is pressed, the Sleep time will be decreased in a 10 minutes decrement.
The unit will play for the selected length of time then automatically turn off.
5.) To turn the unit off before the selected length of time, press and hold the
POWER/FUNCTION
button at any time.
AUXILIARY INPUT
This unit provides an auxiliary audio signal input jack for connecting external audio
devices like MP3 players, CD players and older, non-dockable iPods (except iPod
shuffle 3
rd
gen) and listen to your external source through the speakers of this
system.
1. Use an audio cable (not included) with one 3.5 mm stereo plug on each end of
the cable.
2. Plug one end into the Aux-in jack on JiMS-70i and the other end of the cable into
the Line-out Jack or Headphone Jack of your external audio device.
3. Turn on the external audio device.
4. To select auxiliary audio input, press the POWER/FUNCTION button to select
“AUX” mode. The LED display will show “AU” for about 10 seconds and revert
back to the current time.
5. Adjust the volume control on JiMS-70i. Operate all other functions on the
auxiliary device as usual.