Jensen CD-600 Portable CD Player User Manual


 
1. The both units are put into your bag or carrying case when they are not in use.
2. The Main Unit is put in your bag or carrying case during operating.
This is to prevent the unit from being accidentally turned on, resulting in draining the batteries.
NOTE: Never disconnect the Remote from the Player while a CD is Playing. Stop the CD first and make
sure the Player is OFF before connecting or disconnecting the Remote from the Player. Abnormal
operation may occur if the Remote is connected to or disconnected from the Player during playback.
To Enhance the Bass Sound
Set the BBS switch to the ON position.
NOTE: The bass boost performance will be increase or decrease depending on the
Volume level.
Turning Power On and Off
To turn ON and OFF, press the following buttons after a disc is inserted into the player.
To turn ON : Press PLAY/PAUSE button (playback starts)
To turn OFF : Press STOP button once for standby mode.
Press STOP button again to turn off the power.
To Remove the Disc
1. Slide the LOCK switch (5) to its original position.
2. Press the CD LID OPEN button to open the CD compartment lid.
3. Hold the edge and gently press the center pivot as illustrated, then pick up the disc.
CAUTION: WAIT FOR THE DISC TO STOP SPINNING BEFORE SLIDING THE OPEN SWITCH
AND OPENING THE LID.
Notes on CD-R/RW Discs
- Because of non-standardized format definition/production of CD-R/RW, playback quality and performance is
not guaranteed.
- Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions such as PC
performance, writing software, media ability, etc.
- Do not attach a label or seal to either side of the CD-R/RW. It may cause a malfunction.
LCD DISPLAY INFORMATION
When the is pressed at initial start up
The display will show “- -“ and then the total number of tracks and total playing time. The disc will start
playing and the display will show the first track number and instant playing time.
To review the total number of tracks and total playing time of the disc, press the STOP button once.
During PLAY mode
The track number and instant playing time are displayed. The ASP indicator will flash and then alight.
During PAUSE mode
When the track playback is paused, the playing time flashes.
Battery Low Indicator
A flashing battery indicator appears in the display when the batteries need to be changed.
VARIOUS PLAY MODES
REPEAT
Every time the MODE button is pressed, the corresponding mode appears in the display window, in the following
sequence: