Jensen CD-480 Portable CD Player User Manual


 
E-7
RADIO OPERATION
1. Slide the FUNCTION SWITCH to AM or FM as desired.
2. Rotate the TUNING KNOB to your desired radio station according to the DIAL SCALE on the TUNING
KNOB.
3. Rotate the VOLUME CONTROL to adjust to the desired output level.
4. To turn off the radio, slide the FUNCTION SWITCH to “AUX IN”.
TIPS FOR BEST RECEPTION
AM – The AM antenna is located inside the cabinet of the unit. If AM reception is weak, change the position
of unit until the internal antenna picks up the strongest signal.
FM – During FM reception, always keep the FM TELESCOPIC ANTENNA fully extended and rotate it until
you get the best reception.
CD OPERATION
NOTE: This unit not only plays commercial compact discs but also self-complied CD-RW discs.
Because of non-standardized format definition/production of CD-R/RW, playback quality &
performance is not guaranteed.
Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions such as
PC performance, writing software, media properties etc.
Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a malfunction.
PLAY MODE
1. Slide the Function Switch to the “CD” position. The LCD backlight turns on.
2. Open the CD DOOR by pressing the CD DOOR where OPEN/CLOSE is mark, load a CD with the label
side facing upward and then close the CD door.
3. Disc information (total number of tracks) will appear on the LCD display.
4. Press /II (PLAY/PAUSE BUTTON) to start playing the CD. The PLAY/PAUSE “” will light steadily.
5. While playing, press /II to pause, the PLAY/PAUSE Indicator “” and the track no. will flash. Press
/II again to resume playing.
6. Adjust the VOLUME CONTROL to the desired volume level.
7. Press (STOP BUTTON) to stop playing.
NOTE: If skipping occurs during CD play, try turning the volume down.
Do not open the CD DOOR when a CD is playing.
REPEAT MODE
Repeat 1
When the REPEAT BUTTON is pressed once, the REPEAT 1 INDICATOR, “REPEAT 1”, will light steadily.
The current track will be repeated until it is interrupted.
Repeat All
When the REPEAT BUTTON is pressed twice, the REPEAT ALL INDICATOR, “REPEAT ALL”, will light
steadily. The whole disc will be played continuously.
To Cancel Repeat Function: Press the REPEAT BUTTON until the repeat indicator is off.
SKIP AND SEARCH MODE
1. During Play or Pause mode, tap the SKIP FORWARD "►► / ►►|" or SKIP BACKWARD "◄◄ / |◄◄"
BUTTON to go to the next track or go back to the beginning of the current track.
2. During play mode or Pause mode, press and hold the SEARCH FORWARD "►► / ►►|" or SEARCH
BACKWARD "◄◄ / |◄◄" BUTTON to search within the current track with audible high speed playback.