Connect the plug of the stereo earbuds (included) into the PHONES socket.
CAUTION
• AVOID EXCESSIVE VOLUME LEVELS FOR LONG PERIODS OF TIME
WHEN USING THE HEADPHONES. PROLONGED USE AT HIGH LEVELS
MAY IMPAIR YOUR HEARING.
• Do not use earphones while operating a motorized vehicle, as it
may create a traffic hazard and is illegal in many areas.
NOTE: This unit can also play 3 inch (8cm) single CDs without an adaptor. Do not
use a CD single adaptor for these smaller discs.
1. Press the CD LID OPEN button to release the CD lid.
2. Insert a disc with the label side facing up.
3. Close the CD Lid. A click will be heard when it locks into
place.
4. Press the PLAY/PAUSE
button once to start playing.
5. The display will show the total number of tracks and
playing time. The player will then start playing the first track.
6. Adjust the volume by turning the Volume Control.
Locating a Particular Track
Locating a Particular Point in a Track
Turning Power On and Off
To turn ON and OFF, press the following buttons after a disc is inserted into the
player.
To turn ON : Press PLAY/PAUSE button (playback starts)
To turn OFF : Press STOP button once for standby mode.
Press STOP button again to turn off the power.
Auto power-off function
When the unit is stopped (Standby mode) for approximately 30 seconds, the
power is automatically turned off.
To Remove the Disc
1. Press the CD LID OPEN button to open the CD
compartment lid.
2. Hold the edge and gently press the center pivot as
illustrated, then pick up the disc.
CAUTION: WAIT FOR THE DISC TO STOP SPINNING BEFORE SLIDING
THE OPEN SWITCH AND OPENING THE
LID.
When the button is pressed at initial start up
• The display will show “- -“ and then the total number of tracks and total playing
time. The disc will start playing and the display will show the first track number
and instant playing time.
• To review the total number of tracks and total playing time of the disc, press
the STOP button once.
During PLAY mode
• The track number and instant playing time are displayed.
During PAUSE mode
• When the track playback is paused, the playing time flashes.
Battery Low Indicator
A flashing battery indicator flashes in the display when the batteries need to
be changed.
To skip back to the beginning of the
current or a previous track
Press
once or repeatedly.
To skip to the beginning of following
tracks
Press
once or repeatedly.
To search back at a high speed Press & hold
To search forward at a high speed Press & hold
EARPHONES CONNECTION
BASIC OPERATION
LCD DISPLAY INFORMATION
EN-7
EN-6