Filter
Top Products
1. LCD Display
2. DC Power Jack
3. Battery Compartment
Cover (bottom)
4. Play/Pause Button
5. Volume Control
6. CD LID Button
7. Headphones Jack
8. Stop Button
9. Next Button
10. Previous Button
11. Mode Button
12. Program Button
13. CD Door
This CD player operates on two 1.5V DC ‘AA’ size (UM-3) alkaline batteries (not
included) or with an AC adaptor with an output of 4.5VDC/700mA (not included).
To install batteries into the player
1. Open the battery compartment cover located on bottom of
cabinet.
2. Insert two 1.5V DC ‘AA’ size (UM-3) alkaline batteries (not
included) into the Battery Compartment following the polarity
markings as indicated in the compartment.
3. Close the battery door and completely slide it back to its
original position.
Battery care
i. Be sure that the batteries are installed correctly. Wrong polarity may
damage the unit.
ii. (a) Do not mix old and new batteries.
(b) Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-
cadmium) batteries.
iii. If the unit is not to be used for an extended period of time, remove the
batteries. Old or leaking batteries can cause damage to the unit and
may void the warranty.
iv. Never attempt to charge “Non-rechargeable” batteries.
v. Do not dispose of batteries in fire, batteries may explode or leak.
Using an adaptor (not included) to power the player
1. Before connecting the adaptor to the player, make sure that the AC voltage of
the adaptor corresponds to your local AC outlet voltage. The polarity of the
adaptor must match to the polarity markings next to the DC jack on the player.
2. Plug the 4.5VDC/700mA AC-DC adaptor into
an AC outlet.
3. Insert the DC plug into the jack on the player.
NOTE: When the adaptor is connected, the batteries will be automatically
disconnected and the player will now operate on the adaptors power.
Once the adaptor is unplugged the player will automatically switch to
back to battery power.
LOCATION OF CONTROLS
POWER SOURCE
EN-4 EN-5