Filter
Top Products
LINE
MIC
O
U
T
P
U
T
1
I
N
P
U
T
LOOPMIX
R-PEAK
G-SIGNAL
1
2 & 3
2 & 3
2
3
10
Indicators
PEAK / SIGNAL
The PEAK / SIGNAL LED (Light Emitting Diode) is a two-color device. Red indicates that the
system is approaching clipping. The threshold for this light is actually about 2 dB below clipping.
An occasional flicker of the red LED on the loudest peaks is acceptable. If this LED remains red
for more than the duration of brief dynamic peaks, the system is being overdriven. Continuously
over driving the system will result in unpleasant and fatiguing distortion and may lead to premature
failure of your speaker system.
If the red LED illuminates excessively:
• Reduce INPUT 1 and INPUT 2 & 3.
• Reduce the output level of the mixer, musical instrument, or other source to the speaker.
Green indicates a usable signal is present at INPUT 1 and/or INPUT 2 & 3.
MIC
This LED illuminates to indicate that the MIC/LINE switch is in the MIC (depressed) position.
VOLTAGE SELECTION AND FUSES
Changing Voltage
Your EON10 G2 will typically be set at the factory to accommodate the power mains voltage in your area. Before
you set up your EON10 G2 for the first time it is a good idea to verify that the setting of the selector is appropriate
for the power in your area. Directly above the power switch you will see a seal that indicates the factory setting for
the voltage. If the voltage indicated is correct for your area, go ahead and power up your EON10 G2.
In the event that you do need to change the voltage selection:
• Make sure that the AC is disconnected from the speaker.
• Directly above the power switch on the speaker is a voltage selector. Peel off the
factory-applied seal.
• Set the voltage selector switch to the 115V or 230V setting as required for your area.
• After having reconfirmed that the correct voltage is selected, connect the AC
(IEC connector) and power the unit up.
DO NOT UNDER ANY CIRCUMSTANCES OPERATE THE UNIT WITH THE WRONG
VOLTAGE SELECTED. DOING SO MAY RESULT IN SERIOUS DAMAGE TO YOUR
SPEAKER SYSTEM WHICH WILL NOT BE COVERED BY WARRANTY.
Fuse Replacement
The EON10 G2 has no user-serviceable fuses. Failure of fuses is most frequently a symptom of problems requiring
service by a competent technician.