Filter
Top Products
5
English
Notes: For the sake of simplicity, throughout this manual we have
used the term “source” when describing connections and operation.
This would apply to any device such as an A/V receiver, audio
component, computer or portable music player.
The JBL On Air may be connected to your source in several ways.
First, determine how you would like to use the JBL On Air
Control 2.4G AW; then follow the setup instructions for that
application.
Application 1
Adding surround speakers to a home theater system.
Continue reading the instructions for Application 1 below.
Application 2
Adding speakers to remote locations around your home.
Application 1
Adding surround speakers to a home theater system:
Determine if your source contains preamp outputs for rear/surround
channels, usually indicated by RCA-type jacks on the back of the
receiver labeled as “surround preout” (please refer to your source’s
owner’s manual to confirm whether it includes the preamp outputs).
If your receiver includes these outputs, follow the steps below.
If not, connection is not recommended.
NOTE: Make sure power is turned off on all components.
Step 1.
Connect the interconnect cable (included) to the left and right
surround/rear preamp outputs on the back of your source and the
input on the transmitter module
D
, as shown in Figure 1.
CONNECTIONS
Left
Surround
Channel
Right
Surround
Channel
Left Front
Channel
Subwoofer
Right Front
Channel
Center
Channel
INPUT
RL
R
L
ID
CODE
1234
Surround Channel
Preamp Outputs
RECEIVER/PROCESSOR
Figure 1.
Step 2.
Determine the location of the surround speakers.
Figure 2. Place the active (left) speaker in the recommended
location for the left surround speaker.
Left
Surround
Channel
Right
Surround
Channel
Left Front
Channel
Subwoofer
Right Front
Channel
Center
Channel
Couch
0039CSK JBL On Air Control_2.4_AW_ENG_v5_GODKENDT:34199_Control_2_4G_Eng 10/06/08 15:57 Side 5