Filter
Top Products
10
Wall-Mounting the Speakers Using
Third-Party Wall Brackets
Each JBL On Air Control 2.4G AW wireless speaker contains a
1/4"-20 threaded insert on the back to facilitate the use of third-party
wall brackets. Please consult your JBL dealer or distributor for
recommendations.
NOTES: Customer is responsible for proper selection and
installation of appropriate third-party wall brackets.
The threaded insert on the bottom of the speaker is not intended for
wall-bracket attachment. It is provided for use with an appropriate
third-party floorstand.
Stand-Mounting the Speakers
Each JBL On Air Control 2.4G AW wireless speaker contains a
1/4"-20 threaded insert on the bottom to facilitate the use of third-
party floor stands. Please consult your JBL dealer for
recommendations.
NOTE: Customer is responsible for proper selection and installation
of appropriate third-party wall brackets and/or floor stands.
Wall-Mounting the Transmitter Module
Step 1. Insert the two M3 x 4 machine screws through the wall
bracket and into the rear of the transmitter module, as shown in
Figure 6.
Figure 6.
Step 2. Attach the transmitter module with wall bracket to the wall
using suitable hardware, and wall anchors if necessary.
Remote Control Battery Replacement
CAUTION:
When replacing the lithium battery in the remote, make sure that the
replacement battery is inserted in correct polarity. Place the battery so that
its positive (+) side faces up with the tray held so that the surface with the
dot is facing up.
Remote-control-battery installation
CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY
REPLACED.
REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE (CR2032).
WARNING: DO NOT EXPOSE BATTERIES TO EXCESSIVE HEAT SUCH AS
DIRECT SUNLIGHT, FIRE OR THE LIKE.
Dispose of dead batteries in accordance with local regulations.
MAINTENANCE AND SERVICE
The speaker and transmitter enclosures may be cleaned using a soft
cloth to remove fingerprints or to wipe off dust.
All wiring connections should be inspected and cleaned or remade
periodically. The frequency of maintenance depends on the metals
involved in the connections, atmospheric conditions and other
factors, but once per year is the minimum.
In the event that your system ever needs service, contact your local
JBL dealer or distributor, or visit www.jbl.com for a service center
near you.
Push small tab
toward battery slot.
Pull battery
drawer out.
Insert new battery
with “+” side up, and
slide battery drawer
back into remote.
0039CSK JBL On Air Control_2.4_AW_ENG_v5_GODKENDT:34199_Control_2_4G_Eng 10/06/08 15:57 Side 10