iLive IT209B MP3 Docking Station User Manual


 
9
INSTALLATION
16”
MOUNTINGTHEBARSPEAKERONTOAWALL
We recommend having this bar speaker professionally mounted.
By using the included wall mounting accessories, the bar speaker can be mounted onto a wall.
The included spacers should be used at your discretion to extend the face of the bar speaker farther from the
wall. These are typically used when mounting the bar speaker under a television, and the face of the bar speaker
needstobeushwiththefaceofthetelevision.
RequiredTools
• Manual or Power Screwdriver
• Stud Finder
• Pencil
• Tape Measure
• Level
GettingStarted
1. Use the Tape Measure to decide how high you’d like
to hang the bar speaker on the wall.
The bar speaker must be hung within 6 feet of an
AC power outlet for the attached AC Power Cord to
reach.
2. Use the Stud Finder to locate 2 parallel wooden studs
to screw the mounting brackets into.
3. Mark the wall at the center of the studs using the
pencil.
4. Line the level up on both of your marks to make
sure they are level. If they’re not, adjust the marks as
needed to make them level.
5. After you’ve double checked your markings, drill
through the top hole on both mounting brackets
directly into the marks you’ve made on the wall.
If you are using the brackets only and no spacers,
use the included short screws. If you are using any
of the spacers or combination of the spacers, use the
long screws.
6. Use the Level to level each of the hanging brackets,
then drill the second screw into the bottom hole on
both mounting brackets.
7. Slide the bar speaker onto the mounting brackets,
andmakesurethereisarmandstableconnection
before letting go of the bar speaker.
8. Finally,usetheLeveltoconrmthatthebarspeaker
is level.
IT209
IT209
screws
studs
mounting
bracket
spacer