iLive IBCD2817DP MP3 Docking Station User Manual


 
10
Operations
Setting the Clock
a. Press and hold the CLK SET button.
b. While holding the CLK SET button, press the PREV/SEARCH/HR. button to cycle up through the hours.
Press the NEXT/SEARCH/MIN. button to cycle up through the minutes
c. Release the CLK SET button to set the specied time.
Listening to the Radio
a. Toggle the AM / FM ST / CD / IPOD (AUX) switch to AM or FM ST.
b. Use the TUNING dial to adjust the AM or FM radio frequency.
The Radio Frequency will display on the LCD Display.
Extend the FM Antenna for better FM reception. To improve the AM reception, adjust the position of
the entire unit, as an AM antenna is built into the unit.
Listening to a CD
a. Toggle the AM / FM ST / CD / IPOD (AUX) switch to CD.
b. Use CD OPEN switch to open the CD Door. Insert a CD here, label-side facing out, then close the CD
Door.
c. Press the PLAY button to begin playing the loaded CD.
Programming a CD
When in Program Mode, “PROG” will blink continuously on the LCD Display.
a. Toggle the AM / FM ST / CD / IPOD (AUX) switch to CD.
b. Use CD Open switch to open the CD Door. Insert a CD here, label-side facing out.
c. Press the PROGRAM button.
• A number will begin blinking on the LCD Display. This indicates the order of the tracks to be
played. For instance, if a 01 is blinking, then the track you select will be the rst to be played.
d. Press the PREV/SEARCH and NEXT/SEARCH buttons to search the CD tracks. Press PROGRAM
once the desired track is found.
• Once you press the PREV/SEARCH or NEXT/SEARCH buttons, the blinking number will change to a
number that is not blinking. This number indicates the CD track.
• Repeat this step to program up to 20 CD tracks.
e. Once the desired tracks are programmed, press the PLAY button to begin playing the programmed tracks.