Filter
Top Products
4
Using the iP56
Using the Aux Line-in Jack
The iP56 has an aux line-in jack located on the back of the unit to play other audio devices.
1. Connect one end of a standard 3.5mm audio cable (available at www.ihomeaudio.com) to the aux line-in jack and the
other end into the headphone or line-out jack on your audio device.
2. Press the Button on the iP56 to turn it on. Make sure your device is turned on, too.
3. Put your device into play mode. Press the or Buttons to adjust the system volume. You may need to adjust the
volume on your device, too.
4.Press the Button to turn the iP56 off. Remember to turn your device off, too.
Note: Do not play an audio device through the aux line-in jack while an iPhone or iPod is playing in the dock or you will hear
both at once.
Resetting the iP56
Your iP56 was designed with a special surge protection circuit to prevent permanent damage to the
unit in the event of an unexpected power surge. If your unit appears to be ‘locked up’ and is not
operating normally, and you know that the battery is properly charged, use a straightened paper clip,
toothpick, or similar object to press the RESET button, located on the back panel next to the AC
jack. This will unlock the unit and restore the original factory default settings.
Reset button located
on back of unit