Filter
Top Products
7
Using the iH51
Connections
Connecting the Subwoofer to the Receiver
1.
The iH51 comes with a connector cable to connect the Subwoofer to the Receiver. DO NOT USE THIS CABLE TO CONNECT
ANY OTHER DEVICE, SUCH AS A COMPUTER. DOING SO WILL DAMAGE YOUR UNIT.
2. Attach one end of the cable to the Subwoofer and tighten the screws until firmly attached.
3. Attach the other end of the cable to the Receiver and tighten screws until firmly attached.
Connecting and setting up the antennas
1.
Snap the AM antenna into the provided stand, then plug antenna cable into AM antenna plug on rear of receiver. Antenna
should be kept 12 inches from unit.
2. Extend FM antenna and locate for best reception. Do not alter antenna wire.
Connecting the Stereo Speakers to the Receiver
1.
The iH51 comes with two sets of audio cables (short and long) so you can set up the speakers to match your setting and
preferences.
2. Plug one end of an audo cable into the jack on the back of the Speaker and the other end into the matching speaker
jack on the back of the Receiver. NOTE: The Right Speaker has a Snooze/Dimmer switch and must be connected to the
matching right speaker jack to operate snooze/dimmer functions from the speaker.
Connecting iH51 to Power Source
1. Once you’ve made all your connections, plug the power cable from the Subwoofer into a standard 120v wall socket.
Unit must be plugged in for the receiver to charge iPod.
Setting the Time Zone
The iH51 clock is preset to U.S. Eastern Standard Time. It is simple to adjust the unit for your location.
1. Depending on your location and whether or not Daylight Saving Time (DST) is in effect, set the DST Switch located on the back
of the unit to +1 to add one hour or to -1 to subtract one hour.
2. Press and hold the Time Zone Button located on the back of the unit until Time Zone Indicator at the lower part of the display
flashes. Press the or Button to select your time zone.
3. Press Time Zone Button again. You will hear two beeps confirming your setting and exit the Time Zone Setting mode.
4. If the time showing is not correct, please see Setting Time and Calendar below to set the clock.
Setting the Clock & Calendar
1. Press and hold the Clock Adj Button located on the back of the unit until the time display flashes. Press the or Button to
adjust the time (hold for a few seconds to advance or reverse rapidly). Remember to set the correct AM or PM hour. An icon to
the right of the time display indicates AM or PM.
2. Press the Clock Adj Button again. The year will flash in the lower part of the display. Press the or Button until the current
year is displayed.
3. Press the Clock Adj Button again. The date will flash. Press the or Button until the current date is displayed.
4. Press the Clock Adj Button once more. Two beeps will sound to confirm your settings and you will exit Time and Calendar
Setting mode.
Please adjust text/number alignment