Filter
Top Products
19
7
SET MODE
New2001
7
D Scan resume timer “St”
The scan resume timer can be set as a pause (OFF) or timer
scan (ON). When OFF is selected, the scan pauses until a
received signal disappears. When ON is selected, the scan
pauses for 5 sec. after receiving a signal and then resumes
even if the signal has been received.
D Auto scan function “AS”
The Auto scan function starts the desired scan automatically
when no signal is received, and no operation is performed for
30 sec.
D Dual/Tri-watch function “dt”
This item selects dual or tri-watch as desired. See p. 16 for
details.
D Monitor switch action “Sq”
The monitor switch action cuts off the squelch function tem-
porarily. This switch action contains PUSH (Pu) or HOLD (Ho)
settings as shown below.
• Pu (PUSH): After pushing the [SQL•MONI] for 1 sec., the squelch
opens and emits audio. The squelch is held open while
continuously pushing and holding [SQL•MONI]. (default)
• Ho (HOLD): After pushing the [SQL•MONI] for 1 sec., the squelch
opens and emits audio even [SQL•MONI] is released.
To close the squelch, push any key.
Push
Push setting (default) Hold setting
Push
Dualwatch function
(default)
Tri-watch function
Push
Auto scan OFF (default) Auto scan ON
Push
Scan resume timer OFF
(default)
Scan resume timer ON
IC-M32-1.qxd 03.9.25 6:21 PM Page 19 (1,1)