IBM 385 (2635) Clock Radio User Manual


 
Symptom-to-FRU Index
The Symptom-to-FRU Index lists error symptoms and
possible causes. The most likely cause is listed first.
Note: Replace the FRUs one at a time in the sequence
shown in the FRUs of the IBM ThinkPad Dock I
Sequence of Action column. If a replaced part did
not resolve the problem, put the original part back
in the IBM ThinkPad Dock I. Do not replace
non-defective parts.
Always begin with “General Preparation” on page 550.
This index also can be used to help you decide which
FRUs to have available when servicing the IBM ThinkPad
Dock I.
Numeric error codes show the errors detected in the POST
or system operation. Xs, when included in the error code,
can be any number.
FRU codes are used for errors detected by diagnostic
tests.
If no error codes are available, use narrative symptoms.
If the symptom is not listed or you cannot correct the
problem using this index, go to “Undetermined Problems”
on page 573.
If you cannot correct the problem using this index, go to
“Undetermined Problems” on page 573.
IMPORTANT:
1. Before replacing any SCSI device, verify that there
are no duplicate SCSI ID settings.
2. Make sure that there are no conflicts of hardware
settings, such as, interrupt level, memory address,
DMA channel, and I/O address.
3. If you have both an error message and an incorrect
audio response, diagnose the error message first.
4. If you cannot run the advanced diagnostic tests, but
did receive a POST error message, diagnose the
POST error message.
5. If you did not receive an error message, look for a
description of your error symptoms in the first part of
this index.
6. Check all power supply voltages before you replace
the main card, riser card, and audio card of the IBM
ThinkPad Dock I. (See “Power Supply” on
page 552.)
ThinkPad SelectaDock Docking System
565