Filter
Top Products
Getting Started (Controls)
20
Remote Control Buttons
Picture of Remote Control
POWER Turns the VCR on and off.
VCR1, TV, CATV, VCR2 Device buttons let you set the remote to control one of four
devices.
MUTE (TO CONTROL TV) Turns off the audio until you press Mute again.
VOLUME/SLOW Increase or decrease the audio volume and plays back in adjustable
slow motion.
REW Rewinds the videotape.
PLAY Starts playing a loaded cassette.
STOP Stops a videocassette from playing, recording, pausing, rewinding - or anything
it is doing.
GUIDE Brings up an on-screen setup and programming guide, the Easy Guide System.
TAPE SPEED Switches between standard play (SP) and extended play (EP).
AVX Used for recording from an auxiliary input such as a stereo system.
INDEX Used for marking and searching for specific tape locations.
LAST CHANNEL (TO CONTROL TV) Switches to the channel you watched previously
during the current viewing session.
CHANNEL Top button switches to the next higher channel, bottom button switches to
the next lower channel. For these to operate, you must have preset your channels.
REC Starts recording on the station the VCR is set to. (Press REC and PLAY at the
same time.)
F.FWD Fast forwards the videotape.
PAUSE Temporarily stops the cassette from recording or playing. Press PAUSE again
(or PLAY) to resume.
F.ADV Lets you advance the tape frame by frame.
CLEAR Used in on-screen programming and indexing.
DISPLAY Used in on-screen programming and indexing.
TRACKING Lets you fine tune the picture.
0 to 9 Number buttons used in on-screen programming. Can also be used to change
channels. (Simply press 2 or 3 digits for the channel you want - such as 0 and 6 for
channel 6, or 100/ENT and 2 and 4 for channel 124.)