Filter
Top Products
Advanced Operations (Second VCR)
48
* When an audio cable is connected to the AUDIO IN jacks, new audio
signals can be recorded on the Hi-Fi tracks.
To begin dubbing
First connect the video source (camcorder, VCR, etc.) to the input jacks
on the front of your VT-F482A. (see example on page 58)
Press the AVX button (located on the remote control) to select L2 (line
2) which appears in the VCR's channel display.
Find the place on the tape which will become the start point for your
video dub. This can be done using the PLAY button and the SHUTTLE
dial. Pause the tape when you reach your start point.
Press the DISPLAY button (located on the remote control) to display the
counter reading in the VCR's display. The number shown will be your
"start point".
To find the "end point" of your video dub play or search through the tape
until you find the place where the video dub will stop.
Press CLEAR (located on the remote control) and the VCR display will
read "0:00:00".
Rewind the tape to the "start point" using the SHUTTLE dial. By using
the SHUTTLE dial you can find the exact spot you wish the dubbing to
start.
Press the V.DUB button on the remote control. Then press the PAUSE
button to begin video dubbing. The VCR will stop automatically when the
counter reads "0:00:00" (the "end point").