Filter
Top Products
12
REAR PANEL JACKS
Q Antenna Input/Output
The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and
ANT B. ANT A input can be displayed as a main picture or sub-picture. ANT B can only be displayed as
a main picture. (ANT B cannot be displayed as a sub-picture.) The antenna output labeled "TO
CONVERTER" allows the ANT A connection to pass directly to a different source such as a cable box,
when ANT B is displayed as a main picture.
R Audio/Video Inputs 1and 2
The INPUT button will step through each video source and antenna source input each time it is pressed.
Use the audio and video inputs to connect external devices, such as VCRs, camcorders, laserdisc players,
DVD players, etc. (If you have mono sound, insert the audio cable into the left channel jack).
NOTE: You may use VIDEO, S-VIDEO, or COMPONENT: Y-PB-PR inputs to connect to INPUT 1 and
2, but note that only one of these may be used at a time.
S Monitor Out
These jacks provide fixed audio and video signals which are used for recording. Use the S-VIDEO Output
for high quality video output.
NOTE: S-VIDEO Output may be used for recording, only when the input is of S-VIDEO type.
(4) Audio to Hi-Fi Output
These jacks provide variable audio output to a separate stereo amplifier. With this connection, the audio to
the stereo can be controlled by the television's main volume.
(5) S-Video Inputs 1 and 2
Inputs 1 and 2 provide S-Video (Super Video) jacks for connecting equipment with S-VIDEO output
capability.
(6) Component: Y-PB-PR Inputs
Inputs 1 and 2 provide Y-PB-PR jacks for connecting equipment with this capability, such as a DVD
player or Set Top Box.
NOTE:
1. DO NOT connect standard VIDEO or S-VIDEO to Input 1 or 2 when using Y-PB-PR input.
2. When using the Y-PB-PR input jacks, connect your components audio output to the TV's Input 1 or 2
Left and Right Audio input jacks.
3. Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y
output to the TV's PB input and the components R-Y output to the TV's PR input.
4. Your component outputs may be labeled Y-CB-CR. In this case, connect the components CB output to
the TV's PB input and the components CR output to the TV's PR input.
5. It may be necessary to adjust TINT to obtain optimum picture quality when using the Y-PB-PR inputs.
(See page 54.)
6. To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the Y-
PB-PR jacks.
7. When using the Y-PB-PR jacks, PIP sub-picture can not be turned ON. It is not possible to view a Y-
PB-PR input, while PIP is ON. (See page 25)