Filter
Top Products
Operations
16 HP StorageWorks 3800ux/7100ux Optical Jukebox User’s Guide
■ SCSI ports—68-pin high-density SCSI connectors (Micro D-type). Used for
attaching the SCSI cable from the jukebox to the host computer. One port
must have a SCSI cable connected, and the other must have a SCSI terminator
connected to it.
■ Power cord clip—Used to route the power cord away from other connectors
and provide strain relief for the power cord connection.
■ Product serial number label—Needed for service calls. Write down your
jukebox serial number before you call your service representative.
■ Access panel and mounting screws—Covers the interface and power
connection components. The panel is secured by two screws on the lower
corners.
Note: Two screws secure the customer access panel to the side of jukebox during
shipment from the factory. These screws are removed during unpacking but
should be replaced after installation is complete. If the jukebox is ever reshipped,
these screws must be in place to properly secure the access panel.
■ Cable access hole—Used to pass SCSI and power cables through the cabinet
to the inside of the jukebox.
■ Power switch—Turns power to the jukebox on and off.
■ Power receptacle—Used for connecting the power cord to the jukebox.
Located on the bottom of the power distribution assembly.
WARNING: TThis product can only be used with an HP approved power cord
for your specific geographic region. Use of a non-HP approved power cord
may result in: 1) noncompliance with individual, country-specific safety
requirements; 2) insufficient conductor ampacity that could result in
overheating with potential personal injury and/or property damage; and 3) a
fractured power cord, which could cause the internal contacts to be exposed,
which potentially could subject the user to a shock hazard. HP disclaims all
liability when HP-approved power cords are not used.