Filter
Top Products
Viewing the on-screen displays
Your TV provides you with on-screen displays. To see the displays:
1 With the power on, press DISPLAY.
The on-screen display will show the channel you are watching, the
time of day, and the amount of time left on the sleep timer (if the
sleep timer is set).
✓ To remove the displays, press DISPLAY a second time.
✓ If you are not using Closed Captions, will not appear when you press
DISPLAY. Please see page 21.
Setting the sleep timer
The sleep timer allows you to select the length of time your TV
remains on before turning off automatically. This is especially
convenient if you like to fall asleep with the television on.
Repeatedly press the
SLEEP button to set the amount of time you
want the TV to remain on.
A display will appear in the corner of the screen.You can set the
timer for one of the following lengths of time: 10, 20, 30, 60, 90, 120,
150, 180, 210, 240, 270, 300, 330, or 360 minutes.
2 To cancel the sleep timer, press SLEEP until the on-screen display
reads “Off.” You can also cancel the sleep timer by turning the TV
off, then turning it on again.
Viewing a VCR or camcorder tape
When you connect a VCR or camcorder to your TV with the A/V jacks,
you need to adjust your TV. To do this:
1 Press the TV/VIDEO button when you wish to view a video tape, a
video game, or any signal from equipment connected to the TV’s
A/V jacks.
✓ If you do not have any equipment connected to the A/V jacks, the TV will
display the message, “Connect the A/V jacks.”
If you have equipment connected to both the front and the rear A/V
jacks, the TV will only display the signal from the front A/V jacks.
If you have equipment connected to either the front jacks or the
rear jacks (but not both the front and the back), the TV will
automatically display the signal from the connected equipment.
2 To return to normal TV viewing, press TV/VIDEO again.
CC
ANT 11
CC
2:48pm
Sleep 10
TV O
PERATION
18
C
HAPTER
T
HREE
: TV O
PERATION
1
1
2
1
2
1547290B (MG20-E) 3/29/01 10:26 AM Page 22