Filter
Top Products
6
C
HAPTER
T
WO
: I
NSTALLATION
C
HAPTER
T
WO
I
NSTALLATION
Connecting VHF and UHF antennas
If you do not have cable TV, you will need to connect an antenna to
your TV. To connect an antenna, follow the instructions in one of the
following sections.
• If your antenna has a set of leads that look like the illustration
below, see “Antennas with 300-ohm Flat Twin Leads,”on this page.
• If your antenna has one lead that looks like the illustration below,
see “Antennas with 75-ohm Round Leads,” on page 6.
• If you have two antennas, see “Separate VHF and UHF Antennas,”
on page 6.
Antennas with 300-ohm flat twin leads
If you are using an off-air antenna (such as a roof antenna or rabbit
ears) that has 300-ohm twin flat leads, follow the directions below.
1 Place the wires from the twin leads under the screws on the 300-75
ohm adapter. Use a screwdriver to tighten the screws.
2 Plug the adapter into the terminal on the bottom of the back panel.
INPUT
VIDEO AUDIO
75
1
2
1547290B (MG20-E) 3/29/01 10:25 AM Page 10