Filter
Top Products
PROGRAMMING YOUR EPM3000P
CHAPTER 5
G
ENERAL
P
ROCEDURE
O
VERVIEW
5.1 H
OW TO
U
SE
T
HIS
P
ORTION OF THE
M
ANUAL
This manual contains programming for basic operation, available options and parameters. Using the Table of
Contents or “Quick Reference Guide”, find the programming feature location and read that chapter.
Programming tasks are arranged into nine major GROUPS. Within each GROUP are the specific meter
FUNCTIONS. Outlined is the general approach to alter programming mode values.
1. Enter the Programming Mode.
2. Select the desired GROUP.
3. Select a FUNCTION within the GROUP.
4. After the FUNCTION selection, proceed with DATA ENTRY of the new value for the desired parameter.
5. Proceed to program another location and/or exit the programming mode.
IMPORTANT
: T
HE FULL EXITING PROCEDURE MUST BE FOLLOWED TO STORE ANY NEW PROGRAMMING
.
5.2 S
WITCH
P
ACKS
MAX
AC VOLTS
A B C N
AC AMPS
MAX/MIN
LIMITS
VOLTS
PRINT
PROG
PHASE
NEXT
03.P
AMPS
B C A
I I I
A B C
N N N
I I I
A B C
LM2
LM1MIN
_ _
_
ABC
NEW
ENTRY
PACKGROUP
FUNCTION
GROUPS, Functions, and Switch PACKS
:
• GROUPS are the main category.
• Functions are sub categories of GROUPS.
• Switch PACKS are sub categories of Functions.
T
HE DIAGRAM BELOW ILLUSTRATES THE ARRANGEMENT OF THE THREE CATEGORIES
:
GROUPS
F
UNCTIONS
S
WITCH
P
ACKS
NOTE
: T
HESE ARE VERY SIMILAR TO DIP SWITCH CONCEPT
.
GE Industrial Systems
19