Filter
Top Products
21
GETTING
STARTED
Receiving
and
Transmitting
To activate Weather Alert:
1. Press and hold the WX/CH-ALERT key for more
than one second to activate this mode.
2. Return to regular use of the radio. You will hear a
Weather Service beep tone and observe the
flashing WX Alert display when a weather alert
signal had been detected followed by the severe
weather alert broadcast. (Figure 9)
3. To cancel the Weather Alert feature, press and hold
the WX/CH-ALERT key or turn the unit off.
Receiving and Transmitting
Whenever the VHF 725 is powered-up (On)
it is in the receiving mode. If the unit is monitor-
ing a channel that is broadcasting, you will hear
that transmission. It is possible to monitor any
channel on any band, but transmission on some
channels is not allowed. Many are receive only
channels, while others are simply not intended for
your category of radio use.
To receive on the VHF 725:
1. Press and release the PWR key to turn the unit on.
2. Observe that the display screen will come on and
the last channel accessed will be displayed. If there
is someone transmitting on that channel, you will
hear their communication and the RX symbol will
appear on the LCD display. You may now select
from the many receiving options.
NOTE: For clearer reception, you can adjust the
volume key up or down and set the squelch
threshold to a level at which the audio will be
enabled.
Power Saving Tip!
To monitor the weather
alert feature and save
battery power:
1. Select a weather
channel.
2. Initiate Weather Alert.
3. Reduce volume to
minimum.
4. Press and hold the
LOCK key.
The audio will mute and
the VHF 725 will wake-up
from a lower power mode
to monitor for the weather
alert tone every 5 seconds.
Pressing any key that is
functional during the
LOCK mode will cancel
the Low Power mode and
switch to regular WX/Alert
Mode. A weather alert tone
from the National Weather
Service will also cancel the
Low Power mode and tune
the receiver to the active
weather alert channel at
mid-volume level.