Filter
Top Products
Tablet Dock User’s Guide
9
LOADING MEDIA
(Refer to Figure 8 for the following steps)
To load a disc into your media player drive,
follow these steps:
1. Push and release the eject button on the
front of the drive to open the holder tray. The
tray will come out of the system a short
distance.
2. Gently pull the tray out until a media disc
can easily be placed in the tray.
3. Place the media into the tray, label side up,
with the hole in the center of the disc. Snap
the disc onto the raised circle in the center
of the tray.
4. Gently push the holder tray back in until you
hear a click.
REMOVING MEDIA
(Refer to Figure 8 for the following steps)
1. Push and release the eject button on the
front of the media player drive. This will stop
the drive and the holder tray will come out
of the system a short distance.
2. Gently pull the tray out until the disc can
easily be removed from the tray.
3. Carefully remove the media disc from the
holder tray.
4. Gently push the holder tray back in until
youhear a click.
Do not operate your media drive unless your
system is sitting on a relatively flat surface.
Using the drive when the system is not level
may damage the drive or prevent proper
operation.
There may be a protective sheet in the tray
from when it was shipped; please make sure
it is removed before operating the drive.
Figure 8. Loading/Ejecting Media
Tablet Dock(8-10) 24/3/03, 10:38 AM9