Filter
Top Products
16
Listening To The Radio
1.) Press the POWER button to turn the unit ‘On’.
The display lighting comes ‘On’ and the
display briefly shows “HELLO”.
2.) Press the FUNCTION button to select the TUNER function.
An AM or FM frequency will appear on the
display.
Press the TUNER/BAND button again to
switch between the AM and FM bands if
necessary.
3.) Tune to the desired station as follows:
• Manual Tuning
Repeatedly press the or SKIP/TUNING buttons until the display shows
the exact frequency of the desired station. Use the Manual Tuning method to
tune to weak or distant stations that are not strong enough to be recognized by
the Automatic Tuning system.
• Automatic Tuning
Depress and hold the or SKIP/TUNING buttons until the display begins
to move, then release the buttons. The Tuner will search up or down the band
for the next strong signal and stop on that station. Repeat this procedure until
the tuner stops on your desired station.
4.) If you tuned to an FM Stereo station the ST
indicator will appear in the display. If the FM
Stereo reception is noisy or weak, press the
MODE/FIND button on the remote control to
select the FM Mono mode.
5.) Adjust the VOLUME, DBBS and EQ controls to the desired settings.
6.) When you are finished listening press the POWER button to return the unit
to the Standby (Off) mode. The display lighting goes ‘Off’ and the display changes
from radio frequency to correct time.
PD3689_062005.p65 20/6/2005, 16:1816