Filter
Top Products
4
PREPARATION FOR USE
Unpacking and Set Up
• Carefully remove the unit from the carton and remove all the packing
material from the unit.
• Carefully remove any small strips of tape which may have been used to
keep the CD door closed during shipment.
• Open the CD compartment by pressing the OPEN/CLOSE position at front
of top cover. Inside the CD compartment you will see a dummy CD
protection card which is used to prevent the laser pick-up from moving
during shipment. Carefully remove this card and close the CD door.
• Please save the carton and packing materials in the event that your unit
ever needs to be returned for service. The original carton and packing
materials are the only way to protect the unit from damage during shipment.
• The AC power cord and the remote control handset are located inside the
polyfoam packing material. Make sure that you do not accidentally discard
the accessories with the packing material.
Power Sources
This unit is designed to operate on 8 “C” batteries, not included, or on normal 120V
60Hz AC house current. Operating this unit from any other power source may
cause damage to the unit, and such damage is not covered by your warranty.
Protect Your Furniture
This model is equipped with non-skid rubber 'feet' to prevent the product from
moving when you operate the controls. These 'feet' are made from non-migrating
rubber material specially formulated to avoid leaving any marks or stains on your
furniture. However certain types of oil based furniture polishes, wood preservatives,
or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a
rubber residue on the furniture. To prevent any damage to your furniture we strongly
recommend that you purchase small self-adhesive felt pads, available at hardware
stores and home improvement centers everywhere, and apply these pads to the
bottom of the rubber 'feet' before you place the product on fine wooden furniture.
PD3686_021705r.p65 17/2/2005, 16:144