Filter
Top Products
15
PROGRAMMED PLAYBACK
You can program up to 20 tracks on a disc to play in any desired order.
NOTE: You cannot program a disc during playback. If the disc is playing press the
STOP/CLEAR button first to stop playback and then follow the programming steps
below.
1.) While the total tracks and playing time appear
on the display press the PROGRAM button
once. The PROG indicator and the Program
Number (P – 01) appear, and the track number
(000) flashes.
2.) Press the SKIP FWD or SKIP REV button to
select the first track to be programmed.
Example: Track 2.
3.) When the desired track number is flashing in
the display press the PROGRAM button again
to enter the desired track number in Program
Number 1. The track number returns to “000”
and the Program Number advances to “P – 02”.
4.) Repeat Steps 2 and 3 to program additional tracks up to a maximum of 20.
5.) Press the PLAY/PAUSE button to begin
programmed playback. The PROG indicator
remains in the display and the track display
stops flashing. Playback begins with the first
track you programmed and continues until all programmed tracks have been
played, and then the player stops. The programmed sequence will remain in
the memory until the power shuts off (approximately 20 seconds) or until the
CD door is opened. If you press the PLAY/PAUSE button again before the
power shuts off the programmed sequence will play again.
STOP
STOP
STOP
PLAY
HD7288_ib070703.p65 7/7/2003, 10:5815