Emerson HD2800 Portable CD Player User Manual


 
7
OPERATING INSTRUCTIONS
NORMAL PLAYBACK
NOTE: This player can play all normal CD's plus CD-Rs (CD Recordables) and
CD-RWs (CD Re-Writeables)
1. Connect the headphones to the PHONES jack.
Set the VOLUME control to a low level before you
begin playback and then adjust the volume to a
comfortable level after playback begins.
2. Slide the CD Door OPEN switch to the right to
release the lock and open the CD Door.
3. Place your disc on the center spindle with the
printed label side facing up. Press down gently near
the center hole to make sure the disc is properly
seated on the spindle.
4. Close the door completely until it locks shut.
5. Press the PLAY/PAUSE button. 45 sec
followed by 00 appear in the display as the player
reads the disc. The total tracks and playing time
will appear momentarily and then playback begins
on Track 1. The Anti-Skip indicator comes on and
the playing time shows in the display.
6. Adjust the VOLUME and DBBS (Bass Boost)
controls as desired.
7. When all tracks have been played the player stops
and the display again shows the total tracks and
playing time on the disc. After approximately 30
seconds the power shuts off and the display goes
blank.
To stop playback before the disc ends press the
STOP button at any time. Press the STOP
button again to shut the power off immediately.
To PHONES Jack
VOL.
ON OFF
HD2800_ib.p65 2001/4/9, AM 10:487