Filter
Top Products
5
OPERATING INSTRUCTIONS
Set the VOLUME Control to a low
setting.
1
Rotate the TUNING Control to find
the desired station.
NOTE: If the BAND Switch is set to
the FM STEREO position and you
have tuned to an FM Stereo station,
the FM STEREO LED Indicator will
light.
4
Slide the BAND Switch to a
desired setting – AM, FM, or FM
STEREO.
NOTE: If you select either the FM
or FM Stereo bands, be sure to
raise the FM rod antenna and
extend it to its full length.
3
Slide the FUNCTION Switch to
the RADIO position.
2
If you would like to experience
expanded stereo separation,
press the STEREO-WIDE Button.
The STEREO-WIDE Indicator
illuminates and the sound will
seem to expand as if the speakers
have moved further apart.
5
When you have finished listening,
slide the FUNCTION Switch to
the TAPE (Off) position to shut
the power off.
6
Hints for Better Reception
FM - Make sure that the telescopic FM Rod Antenna is raised and extended to its full length. You may have
to vary the direction of the antenna to find the strongest signal for each FM station. If you are listening to a
weak or distant FM Stereo station and reception is unsatisfactory, slide the BAND Switch to the FM (Mono)
position. This will normally provide an improvement in reception, although the sound will no longer be in
stereo.
AM - The AM ferrite bar antenna is located inside the cabinet. It may be necessary to turn the unit slightly so
that the internal antenna is pointing in the direction of the AM transmitter. You may have to experiment to
find the position that provides the strongest reception for each of your favorite AM stations.
LISTENING TO THE RADIO
PD6528 O/M.QXD 1/16/01 3:50 PM Page 5