Filter
Top Products
11
Open the Cassette Door and
insert a good quality blank
cassette tape into the slots on the
door, with the open end facing up
and the full reel on the right-hand
side. Close the Cassette Door.
Emptiest reel
Open surface side
1
When you are ready to begin
recording, press the cassette
Record
() B
utton. The cassette
Play (➛) Button will also engage.
The tape will begin moving and all
of the material from your selected
source will be recorded on the tape.
3
Select the function you wish to
record, either radio or CD, and
operate that function according to its
own instructions.
2
MAKING A TAPE RECORDING
The tape recorder in this system allows you to make direct recordings from the radio or CD player to a blank
cassette in the tape compartment. An automatic recording volume level control (ALC) circuit will automatically
control the volume level of your recordings to prevent distortion. You may change the settings of the volume
or the Stereo-Wide controls during a tape recording, as these controls have no effect on the material being
recorded onto the tape.
To make a tape recording, proceed as follows:
HEADPHONE JACK
Connect a pair of stereo headphones (not included) to this jack for private listening without disturbing others.
The built-in speakers are shut off when headphones are connected to the headphone jack.
To avoid recording unwanted
material, such as radio
commercials, use the Pause ( )
Button to stop the recording
temporarily. Release the Pause
( ) Button to begin recording
again.
4
If you wish to listen to your
recording immediately, press the
cassette Rewind (❿❿) Button ❶
until the tape rewinds to the
beginning, then press the
Stop/Eject ( ) Button ❷. Set
the FUNCTION Switch ❸ to the
TAPE position and press the
cassette Play (➛) Button ❹ to
begin playback.
3
2
4
1
6
When you are finished recording,
press the Stop/Eject ( )
Button to stop the tape.
5
PD6528 O/M.QXD 1/16/01 3:50 PM Page 11