Filter
Top Products
5
PREPARATION FOR USE
GETTING STARTED
• Operate controls and switches as described in the manual.
• Before turning on the power, make certain that the AC Power cord is
properly installed.
• Store your CDs in a cool area to avoid damage from heat.
• When moving the unit, be sure to first disconnect the AC Power cord.
UNPACKING AND SET UP
• Carefully remove the main unit and the AC Power cord from the display
carton. Remove all the packing material from the unit. Remove any
decorative or descriptive labels from the front or top of the cabinet. Do
not remove any labels from the back or bottom of the cabinet.
• Carefully remove any small strips of tape that may have been used to
prevent the CD door from opening in transit.
• Unwind the AC Power cord and extend it to its full length.
• This unit was shipped with a dummy CD transit card in the CD player.
This dummy CD prevents the laser pick up from moving during shipment.
This card must be removed before you can insert your own CDs. Lift the
CD Door OPEN Tab to open the CD door. Carefully remove the dummy
CD from the player and discard it. Close the CD door.
• Place the unit on a flat, level surface such as a table, desk, counter, shelf,
etc, convenient to a 120V 60 Hz AC outlet, out of direct sunlight, and
away from sources of excess heat, dust, moisture, or strong
magnetic fields.