EAW NT59 Portable Speaker User Manual


 
Section 8 Maintenance and Service
8.1 Maintenance
Your EAW loudspeaker may require little to no regular attention for normal use. However,
performing regular inspections and maintenance can ensure your loudspeaker remains in
optimum operating and cosmetic condition. Refer to the EAW Loudspeaker Manual for
periodic inspection and maintenance recommendations and procedures.
8.2 General Service
CAUTION: THESE SERVICING INSTRUCTIONS ARE FOR USE BY QUALIFIED SERVICE
PERSONNEL ONLY. TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT PERFORM
ANY SERVICING OTHER THAN THAT CONTAINED IN THE OPERATING
INSTRUCTIONS UNLESS YOU ARE QUALIFIED TO DO SO.
WARNING:
Disconnect the ac mains cable before performing any servicing.
Entretien Général
ATTENTION: Déconnectez le cordon secteur avant tout entretien.
Assistenza Tecnica
ATTENZIONE: Disconnettere l'alimentzione AC prima di effettuare qualsiasi intervento tecnico.
Mantenimiento General
PRECAUCION: Desconecte el cable de alimentación antes de realizar ningún tipo de
mantenimiento o reparación.
Service
WARNUNG: Ziehen Sie das Netzkabel aus der Steckdose, evor an der Box gearbeitet wird.
Certain NT loudspeaker components are field replaceable. These include the drivers and
amplifier module. All other service and repair information must be obtained by contacting
the EAW Service Department or the service department of the EAW Distributor for your
country. See the EAW Loudspeaker Manual for contact information. This applies to both
warranty and non-warranty faults.
8.2.1 AC Mains Fuse
CAUTION: To maintain safety approval certifications, use a fuse that meets the specific time
delay, pulse current capability/melting integral (I2t / A2s), and breaking capability listed.
DANGER: Note and be sure to replace the fuse in the same physical orientation as when it
was removed. Double check the circuit board labeling to ensure the orientation is correct for
the proper ac mains input voltage. Failure to follow this warning could result in the incorrect
voltage being applied to the loudspeaker. IF 230 V IS APPLIED TO A 115 V LOUDSPEAKER,
IMMEDIATE AND CATASTROPHIC DAMAGE TO THE LOUDSPEAKER WILL RESULT AND
MAY CAUSE A FIRE HAZARD, SERIOUS PERSONAL INJURY, OR DEATH.
21