Filter
Top Products
3. Carefully lift and turn over the access panel, not damaging
the internal wiring, and rest it on the back of the enclosure.
5. With it tight against
the stiffener and input backer,
screw the bi-amp crossover board
in this position with the 5 supplied
wood screws.
4. Orient the
bi-amp crossover
board so its large
inductor is toward the
input and the smaller
inductor away from the
wooden stiffener.
Position the bi-amp
crossover board tight
against the stiffener
and the wooden
input backer.
NOTE: The illustrations for Steps 3 through 8 are as viewed from the bottom of the enclosure.