Filter
Top Products
Figure 1. Linksys—SIP Diagram
3.0 Setting up the Speaker for Multicast
To set up the speaker for Multicast:
3.1 If you are using CyberData speakers as MGROUPS, complete step 1.1 through step 1.13.
3.2 Go to Voice => SIP and make a note of the multicast address and port number for page groups
(default is 224.168.168.168, port 34567).
3.3 Go to the Speaker Setup on the webpage for the speaker and select MGROUPS and DHCP.
3.4 After the speaker reboots, get the IP address by activating the DTMF switch on the speaker to
announce the new IP address. Enter this new address in the browser to access the speaker's web
page.
3.5 Select the MGROUPS tab and enter the same multicast address and port number in step 3.1.
3.6 Save the settings and reboot the speaker.
3.7 Send a page to the speaker by dialing *96 on the Linksys phone and then selecting the dir
menu.
3.8 Select the corporate directory menu.