Filter
Top Products
OP E R AT ING INS T R UC T IONS
11
6. If you want to repeat a single track, press one of the SKIP/TUNING Buttons
one or more times to find the track you want to repeat, then press the
REPEAT button once.
OR
If you want to repeat the entire CD, press the REPEAT Button twice.
7. To cancel repeat mode, press the REPEAT Button again.
To connect an external audio input device:
1. Make sure that your radio is turned off and unplugged from the power
outlet.
2. Plug the left and right audio connectors on an audio cable (not included)
into the L and R AUX IN jacks on the rear side of your clock radio.
3. Plug the other end of the audio cable into the other equipment Audio out jack
on the audio output device.
4. Plug the AC power cord into an power outlet, then press the POWER button
to turn on your radio.
5. Press the FUNCTION Button one or more times until AUX appears on the
display.
6. Turn on the external audio device and use the device's controls to control
playback.
Maintenance
To clean the exterior
* Use a soft cloth dampened with luke warm water only to clean the exterior
of your radio.
* Make sure that you do not drip water into your radio.
* Do not use solvents, such as benzene, because they may damage the
finish.
Caring for discs
* A dirty, scratched, or warped CD may cause skipping or noise.
.