Filter
Top Products
6 7
The Crosley Dock Clock uses a battery backup system
to maintain your clock and alarm settings during a
power outage. In the event of a power outage, the
battery backup will save your time and alarm settings
until power is restored. The display light will also turn
off until power is restored. To utilize the battery backup,
you must install two AA batteries. The battery backup
will not operate unless batteries are installed. To install
batteries, follow the instructions below.
1 Remove the Battery Compartment Cover (18)
from the back of the unit.
2 Install two new AA batteries in the correct position
as shown inside the battery cover.
3 Reinstall the Battery Compartment Cover (18).
NOTE :
Do not different batteries
Do not mix old and new batteries
Getting Started
Setting the Clock and Date
1 Press and hold the Clock Adjust Button (8).
The clock Display will flash.
2 Turn the Tune Knob (1) until the current time is
displayed (in 12hour mode, a PM indicator
appears when time is set to PM; there is no AM
indicator.)
3 Press the Clock Adjust Button (8) to accept the
time. The year display will flash.
4 Turn the Tune Knob (1) to adjust the year and
press the Clock Adjust Button (8). The date
display will flash.
5 Turn the Tune Knob (1) to adjust the date and
press the Clock Adjust Button (8). The setting
is complete.
1
Plug the included AC adaptor cable into the
AC Adaptor Jack (19) and the other end into a
standard 120V wall socket. It does not operate
on batteries.
31
22
19
18
20 21
23
24
25
26
27
28
29
30
17
Unit Controls
Remote Controls
17 Telescopic Antenna
18
Battery Compartment
19 AC Adaptor Jack
20 Aux In Jack
21 Headphone Jack
DC15V 1.3A
ANTENNA
AUX IN
VOL
RADIO AM/FM
SNOOZE
DIMMER
iPOD
22 Power ON/OFF Button
23 Volume Up + Button
24 Next track
25 (Band)AM/FM Button
26 Play/Pause
Button
27 Volume Down - Button
28 Previous track
29 Radio Button
30
Snooze/Dimmer Button
31 AC Adaptor
Getting Started
Battery Back Up
Power Source