Filter
Top Products
5
MAINTENANCE
Cleaning the Cabinet
Wipe with a soft cloth. If the cabinet is very dirty, dampen the cloth with a weak
solution of neutral detergent and water, and then wipe clean.
Cleaning the Lens
A dirty lens will cause sound skipping and, if the lens is very dirty, the CD may not
work. Open the disc cover and clean the lens as below.
• Dust or Dry Particles
Using a camera lens brush/blower, blow on
the lens a couple of times, then wipe it lightly
with the brush to remove dust. Then, blow on
the lens once more.
• Fingerprints
If the lens cannot be cleaned by using a brush/
blower, use a dry cotton swab starting in the
middle and working to the outside edge.
HANDLING COMPACT DISCS
This unit is designed to play only compact disc bearing the
identification logo below. Other disc may not conform to the CD
standard and may not play properly.
• Dirty, scratched or warped disc may cause
skipping or noise.
• Handle the disc only by the edges. To keep
clean, do not touch its surface.
• Discs should be stored in their cases after use
to avoid serious scratches.
• Do not expose disc to direct sunlight, high
humidity, high temperatures or dust etc. Pro-
longed exposure to extreme temperatures can
warp the disc.
• Do not stick or write anything on either side of
disc. Sharp writing instruments, or the inks used
in some felttip pens, may damage its surface.
Remove the disc
Hold the edge and gently press the centre pivot
as illustrated, to pick up the disc.
CAUTION:
Wait for the disc to stop rotating before pressing
the OPEN button.
Note: This unit can play 3" (8cm) single CD's
without an adaptor. Do not use a CD single
adaptor for these discs.
4
INSERT WITH
THE LABEL
FACING UP.
PRESS THE CLAWS
AT THE CENTER OF
THE DISC CASE.
PRESS THE
DISC GENTLY
TO INSERT IT.
LIFT OUT WITHOUT
TOUCHING THE
RECORDED SURFACE.
INCORRECT
CORRECT
FROM THE CENTER TO THE EDGE
INCORRECT
CHARGING AND USE OF RECHARGEABLE BATTERIES
Rechargeable Battery Operation
This unit can fully recharge the specified rechargeable battery, in approximately
15 hours. The rechargeable batteries (NOT supplied) should be charged before
they are used for the first time, if they have not been used for a long period (over
60 days).
1. Open the battery compartment cover and
insert two of the recommended recharge-
able batteries, matching polarity. (1.2V
600mA)
BOTH BATTERIES MUST BE OF THE
RECHARGEABLE NICKEL-CADMIUM
TYPE, OTHERWISE THE BATTERIES
MAY EXPLODE OR LEAK.
2. Plug in the AC adaptor and set the Charge
Switch to ON position to start charging.
USE ONLY THE AC ADAPTOR SUPPLIED
WITH THE SET FOR CHARGING.
Note: Charge indicator will illuminate.
3. After 15 hours, please unplug the AC
adaptor and switch the Charge Switch to
the OFF position.
DO NOT CHARGE CONTINUOUSLY FOR
24 HOURS OR MORE. DOING SO CAN
CAUSE THE PERFORMANCE OF THE
RECHARGEABLE BATTERY TO
DETERIORATE.
4. If the operating time decreases drastically even when the rechargeable nickel-
cadmium batteries are properly recharged, purchase a new set of rechargeable
nickel-cadmium batteries.
5. When charging for the first time or after a long time, playing time may be reduced.
In this case, charge and discharge the batteries several times.