Filter
Top Products
English
22 CZ209
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your dealer.
FM Tuner
Frequency Range: 87.9 MHz to 107.9 MHz
Usable Sensitivity: 9 dBf
50dB Quieting Sensitivity: 15 dBf
Alternate Channel Selectivity: 70 dB
Stereo Separation (1 kHz): 35 dB
Frequency Response (±3 dB): 30 Hz to 15 kHz
AM Tuner
Frequency Range: 530 kHz to 1710 kHz
Usable Sensitivity: 25 μV
CD Player
System: Compact disc digital audio system
Usable Discs: Compact disc
Frequency Response (±1 dB): 5 Hz to 20 kHz
Dynamic Range (1 kHz): 85 dB
Harmonic Distortion: 0.01%
Audio
Maximum Power Output: 200 W (50 W ✕ 4 ch)
Bass Control Action (100 Hz): +14 dB, –14 dB
Treble Control Action (10 kHz): +14 dB, –14 dB
Line Output Level (CD 1 kHz): 1.8 V
General
Power Supply Voltage:
14.4 V DC (10.8 to 15.6 V allowable), negative
ground
Current Consumption: Less than 15 A
Speaker Impedance: 4 Ω (4 Ω to 8 Ω allowable)
Weight / Source unit: 2.69 lb. (1.22 kg)
Weight / Remote control unit:
1.41 oz. (40 g) (including battery)
Dimensions / Source unit:
7" (Width) ✕ 2" (Height) ✕ 6-1/8" (Depth)
[178 (W) ✕ 50 (H) ✕ 155 (D) mm]
Dimensions / Remote control unit:
1-3/4" (Width) ✕ 4-5/16" (Height) ✕ 7/16"
(Depth)
[44 (W) ✕ 113 (H) ✕ 11 (D) mm]
Note:
• Specifications and design are subject to change
without notice for further improvement.
USB/iPod
ERROR 2
(iPod mode)
During the iPod analyse,
failure to achieve the iPod
state or initialize the iPod
driver, unusual detection of
iPod driver.
Switch to the iPod mode again, reset the unit and
iPod.
ERROR 3
(iPod mode)
During the playback, failure
to achieve the iPod state,
unusual detection of iPod
driver.
Switch to the iPod mode again.
ERROR 5
(iPod mode)
The connected iPod is not
recognized.
Disconnect and reconnect the iPod.
ERROR 7
(USB mode)
USB memory device format
error.
Disconnect and reconnect USB memory device. If
device still cannot be recognized, try replacing with
different USB memory device.
Error Display Cause Measure
10. SPECIFICATIONS
Power Output :
20 W RMS x 4 Channels at 4
and 1 % THD+N
Signal to Noise Ratio:
88 dBA (reference: 1 W into 4 )