Filter
Top Products
Installation Instructions SMA-602
7
Figure 8
7. Lower hex nuts holding main plate in place to bring SL-151
to desired height. (See Figure 8)
Adjustments
Location Adjustments
1. Loosen four hex nuts holding plates together. (See Figure 9)
2. Slide SL-151 in either direction until desired mounting
location is reached. (See Figure 9)
3. Tighten four hex nuts holding plates together. (See Figure
9)
Figure 9
Yaw Adjustment
1. Loosen set screw on top slide plate pipe connector. (See
Figure 10)
2. Adjust YAW position until set screw faces target. (See
Figure 10)
3. Tighten set screw on top slide plate pipe connector. (See
Figure 10)
Figure 10
Height Adjustment
1. Adjust hex nuts up or down in order to make sure the SL-
151 is evenly mounted. (See Figure 11)
Figure 11
Projector Installation
1. Refer to SL-151 Installation Manual for details on mounting
projector to SL-151.
removed hex nuts
top slide plate
main plate
bottom slide
plate (underneath)
5
6
2
2
2
1