Filter
Top Products
Installation Instructions SMA-602
5
Assembly And Installation
The SMA-602 pipe adapter assembly was designed to attach
the UL-Listed SL151 lift (not included) to a 1-1/2" NPT or NPSM
following ANSI/ASME B1.20.1 (Schedule 40, 0.154" minimum
thickness steel or aluminum - ASTM B221) threaded extension
column (not included). A minimum of four threads must be
engaged.
Disassemble Pipe Adapter Assembly
1. Unscrew four hex nuts on pipe adapter assembly (A). (See
Figure 1)
2. Remove top and bottom slide assembly plates from main
plate. (See Figure 1)
Figure 1
Attach Main Plate to SL-151 Lift
1. Insert a 3/8-16 x 3 1/2" hex head tap bolt (C) through a 3/8"
washer (E) and through one of three holes on top of SL-151
lift. (See Figure 2)
2. Install a 3/8" washer (E) and a 3/8-16" hex nut (D) over tap
bolt. (See Figure 3)
3. Repeat Steps 1-2 for other two holes on SL-151 lift.
4. Thread each nut completely on bolts. (See Figure 4)
Figure 2
Figure 3
Figure 4
1
hex nuts x 4
top slide plate
main plate
bottom slide plate
(underneath)
(C) x 3
(E) x 3
1
(underside of SL-151)
(D) x 3
(E) x 3
2
4
(D) x 3