Filter
Top Products
SETUP OPTIONS
Cambridge SoundWorks, Inc. supplies screws and plastic
anchors for convenience, but it is the speaker purchaser’s
responsibility to insure that any speaker mounting or
placement is secure, stable and reliable. Cambridge
SoundWorks assumes no responsibility for damage to its
products or any damage to property resulting from speaker
positioning or placement.
SUBWOOFER/AMPLIFIER
The Subwoofer/Amplifier requires no assembly.
SATELLITES
Desktop Placement
Each satellite is shipped with a Desktop Stand installed.
You can also mount the Volume Control to a Desktop Stand
(see page 12).
Shelf Placement (or other flat surface) without the
Desktop Stand
A) Desktop Stand Removal: unscrew the thumbscrew to
release the satellite.
B) Apply the soft, self-adhesive feet to the bottom surface
of each satellite, as shown.
Wall Mounting With Supplied Hardware
Note: Use the “hook and loop” fastener to secure the
volume control to a convenient flat surface if not using the
Desktop Stand
C) Apply the soft, self-adhesive feet to the back of the
satellite as shown. The feet provide mounting stability
and protect the finish of both the wall and the satellite.
D) Install the No.10 screw and anchor in the wall so that its
screwhead protrudes about 3/8 inch.
E) Adjust the screw so each satellite can be hung with just
a small amount of pressure.
6
Apply Feet to
Bottom for Flat
Surfaces
Apply Feet to Back
for Wall Mounting on
Screwhead
Install
Mount Speaker
A
B
D
C
E