Filter
Top Products
5
RADIO OPERATION (continued)
3. Press and hold CD/TUNER ▲ (14) or CD/TUNER ▼ (15) button until a radio station with sufficient signal
strength is found. Repeat this procedure until the desired station is reached.
4. To tune into a weak station briefly press CD/TUNER ▲ (14) or CD/TUNER ▼ (15) repeatedly until the dis-
play shows the desired frequency or when the best reception has been obtained.
5. Extend the telescope antenna and adjust for best reception.
Note: For FM Tuning, ((ST) will show on the LCD display when stereo sound is obtained.
STORING PRESET STATIONS
You can store up to 10 radio station for FM and 10 for AM in the memory. When a preset radio station is
selected. The preset number appears on the display.
Note: If power is turned OFF (or standby switch not ”green”) the memory will be lost.
PROGRAMMING STATIONS
1. Press FUNCTION to TUNER mode.
2. Press AM/FM (5) to select the desired wave band: FM or AM.
3. Press CD/TUNER ▲ (14) or CD/TUNER ▼ (15) to tune to the desired frequency.
4. Press ”PROGRAM” (17) on the unit or remote control, the “PROGRAM” and“01” will start flashing.
The current preset number will be displayed for selection.
5. If you wish to store the radio station to another preset number, press the “ALBUM PRESET”▲ (11) or
the “ALBUM PRESET” ▼ (12) to select the desired preset number.
6. Press PROGRAM (17) on the unit again to restore the radio station. Repeat steps 3 to 6 to store other
preset radio stations.
Note: During program, if no button is pressed within 5 seconds, the system will exit program mode automat-
cally. If power is removed the station memory is lost.
SELECTING STATION
Press “ALBUM PRESET” ▲ (11) or “ALBUM PRESET” ▼ (12) to select the desired preset number. The
preset number, radio frequency, and PROGRAM will appear on the display.
AM/FM
AM
520KHz
FM
87.50MHz
00 P__01
AM
520KHz
FM
87.50MHz
MEMORY